Carbide burrs are tools employed for deburring most hard materials like ceramics, stone, steel, aluminum, plastics and hardwood. They supply precision, and will be used in cutting, shaping, grinding and chamfering hard materials.

Carbide burrs works extremely well on the selection of materials such as metals (including Steel aluminum and surefire) and many types of types of wood. You can use it on acrylics, fiberglass and plastics too. Carbide burrs may last for a long time without chipping or breaking in order that it’s so excellent to use them on soft metals like gold,platinum and silver.

What Are The Attributes of Carbide Burrs In comparison with HSS Burrs?

In comparison with HSS, Carbide Burrs less complicated harder.

The Tungsten Carbide is extremely hard to enable them to provide in wider selection of work than HSS (High Speed Steel).

HSS can’t be as good as carbide burrs if they’re at warm. Carbide Burrs can bear hotness and can run for extended time.

Carbide won’t soften at hot temperature but HSS burrs is opposite. There is no doubt that carbide is a better choice.

The way you use Carbide Burs:

For additional stability, insert the accessory bit into the unit and then back out slightly before tightening around the collet nut or keyless chuck.

Don’t use these for drilling holes or enlarging holes that are below twice the diameter in the cutter. The tungsten carbide surface can readily catch the inside of a hole and break the bit.

Use higher speeds for hardwoods, slower speeds for metals and slow speeds for plastics (to stop melting at contact point).

Start at the lower speed. Then increase towards the speed that gives the most favourable results.

Tend not to apply excessive pressure. It may reduce the spindle and chip cutting edges. Let the bur perform cutting.

Make use of the sides with the cutter for effective cutting. The end cuts poorly and can break pressurized.

Never in-capsulate the bur within the cut. If chattering occurs, increase speed.

When you use aluminium and magnesium, consider some type of lubricant, wax or tallow, since it will help prevent the flutes from loading or packing.

Carbide burs, if used the proper way, will outperform HSS burs by 50
For more information about SD-51 Carbide Burrs browse our new web site