The Xbox One system is already an amazing package by itself. However, with games like Cod 5, Modern Warfare, and Modern Warfare 2, increasing numbers of people find top reasons to get a new said gaming console, or its accessories. One modification is often a a reaction to develop a rapid fire modded Xbox One controller. Allow me to share the steps regarding how to modify your original controller into a rapid fire controller.

Step one. Unscrewing the controller

Before you begin taking your controller apart, take a critical look in the controller first and try to remember which parts go where since you will eventually have to put everything back again. Start by unscrewing every one of the visible screws behind. Following this, before you decide to tug involved, eliminate the batteries to disclose the hidden screws. Remove these also.

Step 2. Preparing the Case

With all the controller facing down, slowly and thoroughly separate leading half of the casing through the circuit board. A hole in case could eventually need to be made. Remember this before putting things back.

3. Placing The Rapid Fire Button

While other ways of modifying the controller tend not to involve installation of a new button, this kind of guide does. In addition this make it easier to adjust the rate of rapid fire, it minimizes tampering to aspects of the circuit board, thereby minimizing the risk of damaging your modded Xbox One console controller.

Remember, kits for the rapid fire controller can be purchased easily. ps4 rapid fire controllers ‘s the button from this kit that is to be placed through the hole within the casing, so install it gently ahead of the circuit board is returned. You might have to snip out a few flaps to generate method for the wires in the kit. This can be accomplished with whether cutter or possibly a set of two scissors.

Step # 4. Soldering

Let’s assume that you know how to properly utilize a soldering iron, attach the red wire on the leftmost pin of a 4-pin horizontal series, as the blue wire solders towards the rightmost pin of the identical series. The black (or green sometimes) wire attaches towards the core of the three vertical series to the correct with the switch.

Soldering is regarded as the crucial key to making the modded Xbox One system controller. The reason being mistakes made with this stage can permanently damage your controller.

Step 5. Putting everything back

Carefully being attentive to the wires, make an effort to close the circuit board and the casing. Pest little tricky because the new wires can get in the form of things. Find a way of those wires to occupy the empty spaces as an alternative to herniated. You could possibly retain the modded Xbox One controller facedown so that the buttons don’t fall and maneuvering the wires can be a little easier. Position the casings together such as the return the screws yet.
You now must verify that the rapid fire buttons work. When they don’t, you may want to restart both your console along with the now modded Xbox One console controller. This would solve the challenge. If it doesn’t then you might have to go over the steps again to verify.

For more information about custom controllers ps4 go to our web site.