The Xbox One console is already a wonderful package in itself. However, with games like Call of Duty 5, Modern Warfare, and Cod : mw2, a lot more people find top reasons to get a new said game console, or its accessories. The type of modification is often a reaction to build a rapid fire modded Xbox One system controller. Allow me to share the steps concerning how to modify your original controller into a rapid fire controller.

Step one. Unscrewing the controller

Before starting taking your controller apart, have a close look in the controller first and attempt to remember which parts go where because you will eventually must put everything back again. Begin by unscrewing all the visible screws at the back. After that, before you tug involved, take away the batteries to show the hidden screws. Remove these too.

Step 2. Preparing the Case

With all the controller facing down, slowly and carefully separate the front 1 / 2 of the casing through the circuit board. An opening in the case will eventually should be made. Keep this in mind before putting things back.

Step three. Placing The Rapid Fire Button

While other methods of modifying the controller tend not to involve setting up a brand new button, this particular guide does. In addition this make it easier to adjust the interest rate of rapid fire, it minimizes tampering with other aspects of the circuit board, thereby minimizing the chance of damaging your modded Xbox controller.

Remember, kits for your rapid fire controller can be bought easily. It is the button from this kit that is to be placed with the hole in the casing, so install it gently prior to the circuit board is returned. You might want to snip out a few flaps to make method for the wires from the kit. This can be done with either a cutter or a set of scissors.

Step 4. Soldering

Let’s assume that you know how to start using a soldering iron, attach the red wire for the leftmost pin of your 4-pin horizontal series, as the blue wire solders on the rightmost pin the exact same series. The black (or green sometimes) wire attaches towards the core of the three vertical series off to the right from the switch.

Soldering is easily the most crucial key to making the modded Xbox One console controller. The reason being mistakes made during this stage can permanently damage your controller.

Step # 5. Putting everything back

Carefully being attentive to the wires, attempt to close the circuit board as well as the casing. Pest little tricky since the new wires will get with respect to things. Have the option for these wires to occupy the empty spaces instead of stuffed. You may retain the modded Xbox One controller facedown so that the buttons don’t fall and maneuvering the wires really are a little easier. Put the casings together along with return the screws yet.
You need to find out if the rapid fire buttons work. If they don’t, you may have to restart your console as well as the now modded Xbox controller. This will solve the problem. Whether it doesn’t then you might have to go through the steps again to check.

To get more information about mod controllers xbox one web page: check here.